Home > Position : News > News

CNC milling can double productivity

Date:2013-08-08 Author: Times:13909

Compared with the machining center, the CNC milling machine is similar to the machining center in other aspects except for the lack of active tool change function and tool magazine. It can drill, expand, ream, countersink, boring and tapping the workpiece, but it is still mainly Used for milling the workpiece. Usually, the following processing content often chooses CNC milling processing:

   1. The curve on the workpiece summarizes the inner and outer shape, especially the non-circular curve and the list curve given by the mathematical expression.

  2. Give the spatial curve of the mathematical model.

  3. The shape is messy, the scale is complicated, and the marking and detection are difficult.

  4. It is difficult to investigate when machining with a general-purpose milling machine to measure and control the inner and outer grooves of the feed.

   5. High-precision holes and surfaces that are harmonious with scale. . A simple appearance or shape that can be milled together in a single device.

  6. The selection of CNC milling can double the productivity and greatly reduce the usual processing content of manual labor. Parts that need to be machined with a slender milling cutter, such as slender deep grooves or small transfer arc parts of high ribs. Simple rough surface. Must be processed according to special tooling and harmonious processing content, such as standardized samples, harmonious flat plates, die tire milling processing, generally speaking, all belong to high-efficiency processing.  

  In face milling, the selected tools have different shapes and varieties according to their application scale. The cutting edge of the tool is heated rapidly due to the conflict of the cutting process, and cools down sharply when idling, and the demand is very severe. Therefore, the blade is required to have impact resistance, abrasion resistance, and heat resistance. , In order to facilitate adjustment and repair, a number of test terminals are planned on the printed circuit board. CNC milling machine users can also use these detection terminals to measure the voltage or waveform difference between a normal printed circuit board and a faulty printed circuit board, and then can distinguish the cause of the fault and the location of the fault. Even, sometimes it is possible to artificially make "faults" on normal printed circuit boards, such as disconnecting wires or short-circuiting components, etc., to determine the cause of the actual fault.

Shenzhen Lixin-iMachining Co., Ltd.

Info@lixin-imachining.com        www.lixin-imachining.com


Message